Bl8457
New Member
I have an ultra 3 80 furnace by Armstrong air conditioning Its from 1992 it was originally wired where the fan will only kick on when the heat kicks on I would like to make it run when I turn the thermo fan switch to (on) so I replaced the two wire cord with a 5 wire
On the thermostat I have (o/b),(y),(r),(g),an (w) now on the furnace blower board I have G,W,C,Y and R
I have connected w and r because those are for the furnace to kick on and then I connected G this is supposed to be for the fan to kick on or off . When I turn the thermo fan setting to on a relay buzzes on the board and the blower acts like it doesn't have enough power to turn completely on I'm not sure what else to do or check any ideas?!!!
On the thermostat I have (o/b),(y),(r),(g),an (w) now on the furnace blower board I have G,W,C,Y and R
I have connected w and r because those are for the furnace to kick on and then I connected G this is supposed to be for the fan to kick on or off . When I turn the thermo fan setting to on a relay buzzes on the board and the blower acts like it doesn't have enough power to turn completely on I'm not sure what else to do or check any ideas?!!!