Young_apprentice
New Member
Sorry for the dramatic title But really i need help big time Ive finally landed an Apprenticeship job with a good guy. I like service work and usally only did (minor ) service work. Now im working for a guy who only does rough plumbing Im awful at roughs/ remodels. I have terrible Spatial awareness and my lay out and design skills are miserable. I dont know much and I start tommorrow. Please anyone With advice post it. I dont care what it is POST IT! Ex: "You need to use long radius bends on a DWV system when going horizontal to horizontal" anything helps even if you think its obvious i Could use it. EX: a toilet is 12"off the wall and its cold water supply is 6" off the centerline of the toilet.
Ugh i have so many questions i bet this is going to be a long thread!! Post anything that comes into your head BTW im from mass so if anyone knows mass code hook it up.
It could be about Wet venting, stack venting, relief venting, battery venting, how to vent a bathroom, Where you run your main drain/vent stack, how you like to vent and drain toilets, lavs etc... Any tips at all would be great
Thanks guys!
YA
Ugh i have so many questions i bet this is going to be a long thread!! Post anything that comes into your head BTW im from mass so if anyone knows mass code hook it up.
It could be about Wet venting, stack venting, relief venting, battery venting, how to vent a bathroom, Where you run your main drain/vent stack, how you like to vent and drain toilets, lavs etc... Any tips at all would be great
Thanks guys!
YA
Last edited: