bluefleetwood
New Member
I really appreciate all of this input.
My current status is:
Boiler pressure still between 20 and 28 PSI. Auto-fill still off. 30PSI Pressure Relief Valve Still dripping.
Assuming a pin hole in the Water Heater, should not the pressure in boiler approach domestic pressure? Or is the PRV preventing that?
I was replacing these PRV's so often that I've install a valve between it and the boiler as not to have to drain the whole system for replacement.
Question, if I close that valve, will I then see pressure increase towards the domestic pressure because there is no PRV at this point?
Hmmmm?
My current status is:
Boiler pressure still between 20 and 28 PSI. Auto-fill still off. 30PSI Pressure Relief Valve Still dripping.
Assuming a pin hole in the Water Heater, should not the pressure in boiler approach domestic pressure? Or is the PRV preventing that?
I was replacing these PRV's so often that I've install a valve between it and the boiler as not to have to drain the whole system for replacement.
Question, if I close that valve, will I then see pressure increase towards the domestic pressure because there is no PRV at this point?
Hmmmm?