I didn't see a BR mode on the wheel but could have missed it. Would I see the level in the brine tank go down? With the line off or on?
I now see the error has been cleared.
Last edited by Gary Slusser; 02-28-2012 at 07:58 PM.
Click Here to learn how to correctly size or program a water softener.
CAUTION, as of Nov 12 2013 all YouTube videos showing how to rebuild a Clack valve have an error in them that can cause damage.
The F cycle water is shooting out the side of the venturi valve when the brine line is disconnected. in BE mode, something is draining into my septic but I can't see the level in the Brine Tank getting any lower. would the float switch being all the way at the top stop this from happening? With the unit in BE mode, there is no water shooting out of the side of the Venturi so does that mean the Venturi is working properly?
ok, in BR mode water is dripping out of the Venturi valve when I take off the Brine Line. Suggestions?
Sounds like a rebuild of the valve is in order, that is if the venturi is clean and all the parts are in the right spots.
I've cleaned the Venturi several times so I would guess at this point it is a valve issue? Sound right? The pieces can go in only one way with the plug fill/flow having the numbers pointed up as per the manual.
Also, again my water level hasn't fluctuated a bit through two recycles and the tank is about 1/2 full. Normal?
See post #2
[B]No, plumbing ain't rocket science. Unlike rocket science, plumbing requires a license[B]
So should I eliminate the water that is in there or will it do it on it's own?