(206) 949-5683, Top Rated Plumber, Seattle
Results 1 to 3 of 3

Thread: Questions on a Goulds JRS10 at 208v.

  1. #1
    DIY Junior Member gbeens's Avatar
    Join Date
    Feb 2012
    Location
    Washington
    Posts
    2

    Default Questions on a Goulds JRS10 at 208v.

    Hi all, I just moved into a place with three-phase running through a shop in addition to the 240 for the house. The home's pump is a Gould's JRS10 that had originally run on the shop's circuitry, but has been tacked into the home's at the expense of a baseboard heater (I think the seller shut the three-phase down for a while when the house was on the market). I was going to just reconnect it to the original wiring and get my baseboard back, but I was surprised to see the tag on the pump mention only 115/230. To me, this tag implies that 208 would not be appropriate for the pump. Does this seem right for all you folks with direct experience here? I suppose they either (a) had the pump running on 120 from the shop, and switched it over to the house's 240 or (b) ran it on 208 from the shop, advisable or not. If I can't run it on the shop's 208, what do I lose by reverting it back to the 120? Just efficiency? It claims to draw 13.4/8.7. Does this translate into a big change on the electricity bill. Thanks in advance for any input on this matter,
    Mark

  2. #2
    DIY Member kevink1955's Avatar
    Join Date
    Nov 2011
    Location
    L.I. New York
    Posts
    31

    Default

    You do not loose anything by running it on 120V except for the size of the wire, I would run #12 for your 13.4A motor. Your name plate rating is strange as the 240 volt rating should be 1/2 the 120V rating. Since the electric meter measures both phases on 240 you will pay the same with double the amps on 120V

    Most motors are dual rated 208/240 but it appears that yours only has a 230V rating, wire it for 120V and be done with it.

  3. #3
    Moderator valveman's Avatar
    Join Date
    Mar 2006
    Location
    Lubbock, Texas
    Posts
    4,154

    Default

    Nearly all 240V motors will run fine on 208V. Just makes it pull and extra amp or so more than when on 240V. Just make sure to only use two of the three phase legs, and make sure you don't use the high or wild leg if there is one.

Similar Threads

  1. goulds submersible can it be tested
    By sunkentreasure in forum Pumps and Tanks Well Forum & Blog
    Replies: 6
    Last Post: 08-23-2011, 09:03 AM
  2. goulds pump
    By marquezrf in forum Pumps and Tanks Well Forum & Blog
    Replies: 1
    Last Post: 07-13-2011, 05:52 AM
  3. Questions on Goulds 5GS pump
    By laffin_boy in forum Pumps and Tanks Well Forum & Blog
    Replies: 6
    Last Post: 09-20-2009, 06:02 PM
  4. impeller on goulds j7s
    By spark in forum Pumps and Tanks Well Forum & Blog
    Replies: 1
    Last Post: 09-08-2009, 10:22 AM
  5. 208v Disconnect Grounding
    By jdh in forum Electrical Forum discussion & Blog
    Replies: 17
    Last Post: 07-03-2008, 06:57 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •