Hi all,
New to the forum and thanks for your help in advance.
I have a clack WS1 system that I bought(used) and installed. I am having issues with the suction/draw from the brine tank. I have dismantled, cleaned and reassembled every part that will come off of this thing, yet it will still not draw. I did disconnect the line at the tank, and put the end into a container of water. It will draw down the water if the container is raised above the control valve, but fill back up if lower than the valve. All of the o-rings/seals "looked" okay when I cleaned it up, but I assume you can't always tell by just looking. Any ideas of what it may be, and what else I can try to troubleshoot?
New to the forum and thanks for your help in advance.
I have a clack WS1 system that I bought(used) and installed. I am having issues with the suction/draw from the brine tank. I have dismantled, cleaned and reassembled every part that will come off of this thing, yet it will still not draw. I did disconnect the line at the tank, and put the end into a container of water. It will draw down the water if the container is raised above the control valve, but fill back up if lower than the valve. All of the o-rings/seals "looked" okay when I cleaned it up, but I assume you can't always tell by just looking. Any ideas of what it may be, and what else I can try to troubleshoot?