(206) 949-5683, Top Rated Plumber, Seattle
Results 1 to 3 of 3

Thread: Mixing valve theory

  1. #1
    DIY Junior Member beautyfish's Avatar
    Join Date
    Jul 2009
    Location
    Pennsylvania
    Posts
    12

    Default Mixing valve theory

    We had our bathroom renovated this year, and this one was a gut job. I didn't do the work this time. About three days ago, my daughter told me that she had lost hot water in the shower. It wasn't dead cold, but there was very little hot. I ran the water, and she was right. It started out warm and got cooler almost immediately. The sink checked out fine, and when I opened up the tub access panel the hot pipe was hot to the touch, so I assumed it was the mixing valve. After a little web research I was able to adjust the valve and now we have hot water. However, I'm now wondering why something like this would happen to a faucet that's only 18 months old, why it would happen so suddenly, and if I should expect the valve or some other component to fail at some point in the near future. I know this is a cliche, but in this 55 year old house it seems like every time I "update" something original (that worked fine for 50 years) with something new, the new stuff just doesn't hold up the same way. Appliances, fixtures, boiler, you name it.

    FYI, the faucet/shower was a Delta model purchased at Home Depot for about $150.

    Thanks,

    Jim

  2. #2
    Moderator & Master Plumber hj's Avatar
    Join Date
    Aug 2004
    Location
    Cave Creek, Arizona
    Posts
    25,633

    Default

    If we knew HOW you adjusted the valve, we might have an answer. There are several possibilities, some having NOTHING to do with the valve itself, that can happen spontaneously. The way you start the "story", implies that you might think that if you had done the work yourself it would NOT have happened, but that is not the case.
    Licensed residential and commercial plumber

  3. #3
    Plumber jimbo's Avatar
    Join Date
    Aug 2004
    Location
    San Diego
    Posts
    9,001

    Default

    The symptom you describe could be indicative of a stuck balancing spool, which may have become unstuck when you "adjusted something". But there are lots of other possibilities, so we would have to be there or see some photos of what you have and what you did.

Similar Threads

  1. Kohler k-401 Mixing valve, Cartridge Repair or Replace?
    By mrspaceman in forum Shower & bathtub Forum & Blog
    Replies: 18
    Last Post: 01-29-2014, 02:54 PM
  2. No hot water from mixing valve
    By Mike_B in forum Shower & bathtub Forum & Blog
    Replies: 3
    Last Post: 01-22-2009, 06:54 AM
  3. crane mixing valve
    By sshakkour in forum Shower & bathtub Forum & Blog
    Replies: 3
    Last Post: 03-26-2008, 04:54 PM
  4. Need to replace Shower mixing valve with separate cutoff valve for inputs.
    By OfficeLinebacker in forum Shower & bathtub Forum & Blog
    Replies: 15
    Last Post: 11-29-2006, 09:06 AM
  5. Mixing valve ?'s
    By TonyBagadonutz in forum Plumbing Forum, Professional & DIY Advice, Tips & Tricks
    Replies: 2
    Last Post: 09-25-2005, 02:28 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •