Hi!
For the past 8 months, there's been a constant drip down the drain valve from my Culligan Iron-Cleer. They system was installed in 2002. The company that installed the system has sent repairmen out at least six times and their "repairs" do not permanently fix the problem. The sealpack and bell crank were replaced TWICE; an extra large blue filter installed to filter additional silt after silt was found & cleaned off valves & other parts; pointer on iron-cleer clock checked on one visit and then fixed on another.
At one point, I let the drip go w/out calling for another repair visit. The drip turned into a flow which eventually resulted in a total loss of pressure. For the past 3 months, I've had the system in bypass mode. Recently, the water began to smell...so I turned it back on. Now, the drip is back....
I'm at a loss because the local Culligan dealer has been unable to diagnose and fix the problem. Any suggestions? Thanks!
For the past 8 months, there's been a constant drip down the drain valve from my Culligan Iron-Cleer. They system was installed in 2002. The company that installed the system has sent repairmen out at least six times and their "repairs" do not permanently fix the problem. The sealpack and bell crank were replaced TWICE; an extra large blue filter installed to filter additional silt after silt was found & cleaned off valves & other parts; pointer on iron-cleer clock checked on one visit and then fixed on another.
At one point, I let the drip go w/out calling for another repair visit. The drip turned into a flow which eventually resulted in a total loss of pressure. For the past 3 months, I've had the system in bypass mode. Recently, the water began to smell...so I turned it back on. Now, the drip is back....
I'm at a loss because the local Culligan dealer has been unable to diagnose and fix the problem. Any suggestions? Thanks!