backwaterdogs
New Member
Was almost too afraid to post this question, but since it's fairly anonymous, here it goes.
Was rouging in a showerfloor drain, at same time finishing the area below. I ran behind on the drain and the drywallers below needed to move on, so I went ahead and got the ptrap and drain line in and everything..that's all fine i think. After I did that I just stubbed in the drain pipe from what will soon be the floor drain in the shower to the afore mentioned p-trap. However, I wasn't sure of the final height I needed as I will be putting in a mortar flow, so just left this several inches above the floor.
What I thought I had done was just primered the p-trap and dry-fitted the drain pipe in. Well, got distracted for while and now getting back to the drain and for the life of me I can get what I thought I only dry-fitted to that p-trap.
Trying to avoid cutting an access panel in the dry wall, but want to be sure that drain pipe is glued in. I got it budge a little but am afraid to use too much force and break the p-trap (done that before)
Any ideas on how to unstick what I'm pretty sure are just two pieces of dry-fitted pvc?
Was rouging in a showerfloor drain, at same time finishing the area below. I ran behind on the drain and the drywallers below needed to move on, so I went ahead and got the ptrap and drain line in and everything..that's all fine i think. After I did that I just stubbed in the drain pipe from what will soon be the floor drain in the shower to the afore mentioned p-trap. However, I wasn't sure of the final height I needed as I will be putting in a mortar flow, so just left this several inches above the floor.
What I thought I had done was just primered the p-trap and dry-fitted the drain pipe in. Well, got distracted for while and now getting back to the drain and for the life of me I can get what I thought I only dry-fitted to that p-trap.
Trying to avoid cutting an access panel in the dry wall, but want to be sure that drain pipe is glued in. I got it budge a little but am afraid to use too much force and break the p-trap (done that before)
Any ideas on how to unstick what I'm pretty sure are just two pieces of dry-fitted pvc?