(206) 949-5683, Top Rated Plumber, Seattle
Results 1 to 3 of 3

Thread: clack ws1 C1 no power

  1. #1
    DIY Junior Member tedward74's Avatar
    Join Date
    Nov 2011
    Location
    ireland
    Posts
    2

    Default clack ws1 C1 no power

    ok first time post and I have read a good lot of the threads.
    I have this installed about 19 months. all was working fine until i looked at it yesterday and there is now power on the screen. water has obviously not been softening for about a week as the salt level hasnt moved. I check under the sink at the 12v power supply is plugged in and hot.
    there is a break connection that has been twisted together with electrical tape about a foot from the 12v plug ie 2 cables had been joined badly by the installer because he realised the wire was too short and needed to extend it.
    could it be the problem is there ie the cables have shorted or is it amore serious problem.

  2. #2
    In the Trades Tom Sawyer's Avatar
    Join Date
    Nov 2010
    Location
    Maine
    Posts
    2,940

    Default

    I would certainly start there.
    [B]No, plumbing ain't rocket science. Unlike rocket science, plumbing requires a license[B]

  3. #3
    DIY Junior Member tedward74's Avatar
    Join Date
    Nov 2011
    Location
    ireland
    Posts
    2

    Default

    ok apologies for the late update on this issue but it took months to sort with the original vendor of the system. eventually they stated the circuit board was blown and they replaced it with a new board that did the trick at no extra cost to me after a lot of haggling back and forth.

Similar Threads

  1. Clack WS-1 CS Pricing?
    By shanlar in forum Water Softener Forum, problems, installation and reviews
    Replies: 7
    Last Post: 05-24-2011, 07:50 AM
  2. Programming my Clack ws-1
    By monkeybrains in forum Water Softener Forum, problems, installation and reviews
    Replies: 1
    Last Post: 02-25-2011, 10:04 AM
  3. Clack WS1 EE settings
    By mgssrs in forum Water Softener Forum, problems, installation and reviews
    Replies: 20
    Last Post: 03-06-2010, 07:19 AM
  4. How do i set-up my clack ws1.25?
    By MOVIE GUY in forum Water Softener Forum, problems, installation and reviews
    Replies: 2
    Last Post: 01-28-2010, 11:46 AM
  5. clack ws1 orphan
    By txs in forum Water Softener Forum, problems, installation and reviews
    Replies: 1
    Last Post: 07-28-2009, 10:51 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •