Good morning, I'm in the process of mounting a frameless glass shower door. First attempt was off by about 1/8".
My mounting holes are 5/16" wide (4 per mounting bracket) and drilled through 1/2" beige travertine. The holes will be hidden behind the mounting bracket.
I picked up a scrap piece of travertine and drilled a couple of 5/16" holes to practice filling and redrilling.
My first attempt was to fill with Bondo. After the product set, I drilled another adjacent hole, but the drill bit just slid into the softer Bondo.
What would be a good product to use in this situation?
My mounting holes are 5/16" wide (4 per mounting bracket) and drilled through 1/2" beige travertine. The holes will be hidden behind the mounting bracket.
I picked up a scrap piece of travertine and drilled a couple of 5/16" holes to practice filling and redrilling.
My first attempt was to fill with Bondo. After the product set, I drilled another adjacent hole, but the drill bit just slid into the softer Bondo.
What would be a good product to use in this situation?