Ehuddle
New Member
The overload on my pump control box has tripped 3 out of the last 4 nights. It only happens at night and we wake up to no water. When I reset it, the pump runs fine all day and then it trips again over night. I have been trying to figure it out with no luck. I measured current in the 3 legs to the pump and got Red = 1.1A, Black = 10.7A and Yellow = 11.0A. I'm not that familiar with electrical issues so I'm not sure if this is normal. I have a 3/4 HP pump that I think is running on 240V. Any suggestions?
Last edited: