Water Heater Connections
- Thread starter Odie130
- Start date
Users who are viewing this thread
That's right. It's a Uponor PEX fitting.
You will need to cut the tubing and then reconnect them.
You will need to cut the tubing and then reconnect them.
Sponsor
Paid Advertisement
Ballvalve
General Engineering Contractor
Except you will need to have the special tool or homeowner connector device ready before you cut.
Normally a water heater has 24" of metal piping before you convert over to PEX or CPVC.
Being that is the case, we use 24" flex connectors, either copper or stainless steel. Not the braided supplies, but the corrugated supplies.
Being that is the case, we use 24" flex connectors, either copper or stainless steel. Not the braided supplies, but the corrugated supplies.
Gary Swart
In the Trades
Those flex connectors are really the DIYers friend when it comes to water heater connections to any kind of pipe!
Similar threads
