I installed a Kenmore softener about 2 weeks ago. I have noticed that it hasn't regenerated since I manually regenerated it after installation. I put it into diagnostic mode to see if it is measuring water flow, and it does show that it is sensing flow, but compared to my previous Kenmore softeners, it does not seem to be measuring water flow accurately. The digits don't run up very fast even with a faucet fully open, but instead they go up about every 2 seconds or so.
I took the turbine out and it spins on its axle just fine.
Any ideas? Seems to me it is acting like it is binding up when actually installed (the turbine, that is) because it spins just fine when out of the housing.