Shallow Well Jet Pump Venturi and Nozzle

Users who are viewing this thread

srmcclur

New Member
Messages
1
Reaction score
0
Points
0
Location
Vermont
Hey. I have a new Dayton convertible jet pump with a shallow well bolt on ejector that I'm installing for a lake house. It's just drawing water from a hose from the lake only about 6 feet in depth and 100' of run.

I bought the shallow well ejector set and it has a variety of venturis and nozzles. It's apparent how the venturi screws into the ejector but there really aren't any directions and I can't figure out how the nozzle installs into the pump/ejector in relation to the venturi.

Sorry for the stupid DIY question...any help is appreciated !
 

Masterpumpman

In the Trades
Messages
729
Reaction score
1
Points
0
Location
Virginia Beach, VA
Website
www.dci-inc.us
The venturi should screw into the bolt on jet assembly, then bolt the assembly to the pump. The 3 venturi's are for different depths vs. pressure. In your case it won't matter much. I'd use the venturi with the largest inside diameter.
 
Top
Hey, wait a minute.

This is awkward, but...

It looks like you're using an ad blocker. We get it, but (1) terrylove.com can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.

If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.
I've Disabled AdBlock    No Thanks