Doing a new drop-in of a MAAX soaker tub with front center drain on a slab floor. I set the W/O kit in cement. I allowed for the thickness of the tiles under the roll top of tub, but I did not calculate for the Kerdi membrane and mortars. The gap between tub base and flange is now almost 1/2" thick. The drain kit will thread it's way down but the gasket obviously will not seat properly.
Is there a washer or spacer available or fabricate for the rubber gasket to seat on?
I'm afraid I may have to chip out the cement and redo.
Is there a washer or spacer available or fabricate for the rubber gasket to seat on?
I'm afraid I may have to chip out the cement and redo.