MrJones2020
New Member
Notable system features: NTI Ti-150 boiler, natural gas.
Aermotor 75 Well pump, mounted to a tank (~35-55psi settings)
I just recently bought a house, and it uses the Ti-150 for both the baseboard heating (2-zones), and for all the homes domestic hot water.
The system works great, except for when zone(s) are active, and you're continuously using domestic; taking a shower for instance. When the pressure gets low (towards 35psi) you seem to lose hot water in the shower. This takes approx. 45 seconds to remedy itself, and then hot water is once again restored; until the next tank fill-up.
Any ideas? Or what other information do I need to provide to better assist in troubleshooting my problem.
Thanks in advance.
Aermotor 75 Well pump, mounted to a tank (~35-55psi settings)
I just recently bought a house, and it uses the Ti-150 for both the baseboard heating (2-zones), and for all the homes domestic hot water.
The system works great, except for when zone(s) are active, and you're continuously using domestic; taking a shower for instance. When the pressure gets low (towards 35psi) you seem to lose hot water in the shower. This takes approx. 45 seconds to remedy itself, and then hot water is once again restored; until the next tank fill-up.
Any ideas? Or what other information do I need to provide to better assist in troubleshooting my problem.
Thanks in advance.