Going from single to double bath vanity question.
Morning everyone, hope everyone is well.
I've been racking my brain trying to figure out the proper way to extend the supply lines as well as drain/vent assembly, but would prefer some advice since this forum came highly recommended. I'm located close to Toronto Ontario, Canada and am a sheet metal worker by trade. I'm comfortable sweating pipes as well as working with abs.
Details:
Picture #1,2.3
Vanity is 61" with an open back so I'd like to make all rough in close to the sink with shuts offs. Since there are drawer in the center that will make installation much more easy I'm hoping.
I have more pictures and details as well as how I believe it should be roughed in but I'm only allowed 4 images so if I'm allowed I can post more on another post.
Thanks
Frank