BSA_Bob
DIY Member
It worked good for two days. The water was cleared up and now its back to rusty/not quite as bad as before/ water again! Its an Elan hostess.quite old but it worked good before and after . some little thing needs looking after. Can you give me some ideas to check.There s also bent paper clip laying on top of the head,It s corroded,and what did the repair guy use this for?? Any ideas on this are greatly appreciated. I maually started the gear backwash------- and did this 4 times,pump seems a little weak and not quite enough water.The faucets run out of pressure now. it shuts off and on at 30 and 50
Last edited: