moshetojinx
New Member
Hello All,
I am about to piece together my first DWV waste and vent lines. The bathroom was remodeled and enlarged to accommodate a 6' tub in a new location. Since I want to keep all in check with codes for MD, I have a few questions please.
First off does any one see something terribly wrong with my current set up?
The problem I think I may encounter is the double 3" sanitary t. the water closet drains into a vent elbow which in turn is connected to the double t, from there it all goes 3 south out to the sewer. I plan on using a 1.3 - 1.6 flow toilet. I could use a 3" single t and reroute the kitchen sink to go from a 1.5 and dump into a vertical 3" which will go into a 3" wye if needed.
The picture is for demonstration. This is close to the actual waste configuration, but the pipe lengths have been shortened on the water closet.
[/IMG]
I am about to piece together my first DWV waste and vent lines. The bathroom was remodeled and enlarged to accommodate a 6' tub in a new location. Since I want to keep all in check with codes for MD, I have a few questions please.
First off does any one see something terribly wrong with my current set up?
The problem I think I may encounter is the double 3" sanitary t. the water closet drains into a vent elbow which in turn is connected to the double t, from there it all goes 3 south out to the sewer. I plan on using a 1.3 - 1.6 flow toilet. I could use a 3" single t and reroute the kitchen sink to go from a 1.5 and dump into a vertical 3" which will go into a 3" wye if needed.
The picture is for demonstration. This is close to the actual waste configuration, but the pipe lengths have been shortened on the water closet.