Very very coommon practice. Make sure to follow the installation instructions for distances to windows, the ground, doors and such.
|
|
|
A chimney to a oil furnace collapsed, and I see the local heating contractor installed a power vent http://s3.pexsupply.com/manuals/1260..._PROD_FILE.pdf with am exhaust pipe that goes outside and just about the ground (not a real chimney)
Anyone hear of this before? It's a high snow area - won't it get covered with snow? They had to shovel away 4 foot of snow outside to install this.
Is that code compliance??
Thank You
Very very coommon practice. Make sure to follow the installation instructions for distances to windows, the ground, doors and such.
The exhaust and intake usually are supposed to be above the snow level. It depends on the specifics of the installation manual. As noted, it is also very important about where it terminates verses things like door, windows, and other intakes and exhausts. This is all spelled out in some detail in the specific device's installation instructions.
Jim DeBruycker
Important note - I'm not a pro
Retired Defense Industry Engineer; Schluter 2.5-day Workshop Completed 2013
It also depends on local code. This wouldn't pass code anywhere in MA that close to the ground due to snowpack related issues, but it might be allowed in TX. I'd be suprised if an inspector would sign off on it that way in NY. Buried in snow next to the house the exhuast will find it's way under siding & sheathing, can present a very serious health hazard, even if the location met all other clearance requirements to operable windows & doors, air intakes, etc. .
Amazingly enough it was installed by a heating company that is very popular and has been around for many years. WTF !
Bookmarks