Caroma toilet water level

Users who are viewing this thread

watergirl

New Member
Messages
1
Reaction score
1
Points
0
My Caroma toilet tank is not filling to the mark. I know I have to adjust the float but how do I do that? Thanks

sydney_inside_tank.jpg

Inside the Caroma Sydney tank
 
Last edited by a moderator:

Gary Swart

In the Trades
Messages
8,101
Reaction score
84
Points
48
Location
Yakima, WA
Usually the float is a plastic cylinder that has a metal rod through the center that acts as a guide. There is a metal clip on the rod to stop the float when the water reaches the full level. The stop point is adjustable by sliding the clip up or down on the rod. Even if you toilet has some variation on the above, it should be fairly obvious as to what limits the rise of the float. That said, if the water level is fairly close to the mark and the toilet is flushing OK, leave it alone.
 

Terry

The Plumbing Wizard
Staff member
Messages
29,942
Reaction score
3,458
Points
113
Location
Bothell, Washington
Website
terrylove.com
Caroma uses the Fluidmaster.
If the adjustment can't be made using the clip, you may need to lengthen it.
 
Last edited:

reyzenrocr

New Member
Messages
1
Reaction score
0
Points
1
Location
San Antonio TX, USA
My Caroma toilet tank is not filling to the mark. I know I have to adjust the float but how do I do that? Thanks

sydney_inside_tank.jpg

Inside I have the same toilet as the one shown in the pic. I do not see an accurate answer from the replies posted. I see that the tube part right beside the dual flushing system looks like it has a blue 'adjustment' ring around it. Does anyone know how to work this ring and know what it's for? I'm just afraid to break the part, thus my question. Thanks

My Caroma toilet tank is not filling to the mark. I know I have to adjust the float but how do I do that? Thanks

sydney_inside_tank.jpg

Inside the Caroma Sydney tank
I have the same toilet as the one shown in the pic. I do not see an accurate answer from the replies posted. I see that the tube part right beside the dual flushing system looks like it has a blue 'adjustment' ring around it. Does anyone know how to work this ring and know what it's for? I'm just afraid to break the part, thus my question. Thanks
 
Top
Hey, wait a minute.

This is awkward, but...

It looks like you're using an ad blocker. We get it, but (1) terrylove.com can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.

If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.
I've Disabled AdBlock    No Thanks