Fernco Ty-Seal Part No?

Users who are viewing this thread

Lakee911

I&C Engineer (mostly WWTP)
Messages
1,254
Reaction score
1
Points
0
Location
Columbus, OH
What's Fernco's part number for the widget to join 4" PVC to a 4" Cast Iron Bell?

Thx
Jason
 

Gary Swart

In the Trades
Messages
8,101
Reaction score
84
Points
48
Location
Yakima, WA
I don't know the part number, but they are all marked as to what combination of pipes they fit, so you really don't have to have a number.
 

hj

Master Plumber
Messages
33,600
Reaction score
1,037
Points
113
Location
Cave Creek, Arizona
Website
www.terrylove.com
tyseal

One reason you did not find it is that they only make connectors for plain end to plain end pipes. For the hub insert you have to go to the Tyler Pipe site.
 

Jimbo

Plumber
Messages
8,918
Reaction score
18
Points
0
Location
San Diego, CA
If you are looking for a donut seal for the bell, you need to measure the ID of the bell and take that measurement to the plumbing supply. I don't see a Fernco that goes over the bell. Try the other supplier mentioned by hj.
 

Dubldare

Plumber/Gasfitter
Messages
284
Reaction score
1
Points
0
Location
MN/ND
donut.gif


http://www.fernco.com/Donut.asp
 
Last edited by a moderator:
Top
Hey, wait a minute.

This is awkward, but...

It looks like you're using an ad blocker. We get it, but (1) terrylove.com can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.

If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.
I've Disabled AdBlock    No Thanks