Fernco Ty-Seal Part No?

[Lakee911]

What's Fernco's part number for the widget to join 4" PVC to a 4" Cast Iron Bell?

Thx
Jason

[Gary Swart]

I don't know the part number, but they are all marked as to what combination of pipes they fit, so you really don't have to have a number.

[Lakee911]

Ya, but I couldn't find it on their website.

Thx,
Jason

[hj]

One reason you did not find it is that they only make connectors for plain end to plain end pipes. For the hub insert you have to go to the Tyler Pipe site.

[jimbo]

If you are looking for a donut seal for the bell, you need to measure the ID of the bell and take that measurement to the plumbing supply. I don't see a Fernco that goes over the bell. Try the other supplier mentioned by hj.

[srdenny]

Check out what hj had to say on this topic in 2001.
http://www.terrylove.com/wwwboard/messages2/17899.html

You might be better off cutting the hub off the end of the pipe and joining the CI to the PVC with a Mission CP44 or an equivalent Fernco coupling.