am118
New Member
Folks,
I'm building a custom shower (78" x 40").
My drain is about 23" from one end.
I was thinking about using a 48" x 48" kerdi shower pan (and cutting it to fit the drain end of the shower) and then using a mortar-sand bed for the remaining shower floor area (about 30" x 40" or so) at the other end.
Is this doable?
Some say not to mix the two systems.
Others say go ahead.
Any advice?
I figured that once the tile is over both, there wouldn't be much difference.
Help?!
J.
I'm building a custom shower (78" x 40").
My drain is about 23" from one end.
I was thinking about using a 48" x 48" kerdi shower pan (and cutting it to fit the drain end of the shower) and then using a mortar-sand bed for the remaining shower floor area (about 30" x 40" or so) at the other end.
Is this doable?
Some say not to mix the two systems.
Others say go ahead.
Any advice?
I figured that once the tile is over both, there wouldn't be much difference.
Help?!
J.
Last edited by a moderator: