Scottb022563
New Member
I am getting error code 1 on my ge softener. It is 6 years old.
I have replaced the resin, seal kit, disk rotor, switch and motor and am still getting the error. I get the error even if I run the unit in bypass mode. I also get the error even if the switch is disconnected. It always stops when it hits the BW indicator on the cam gear. Also as soon as I plug in the unit it immediately goes into regenerate now mode and I can not get it to not be in that mode.
To me it looks like the only part left that could be bad is the control unit. Any suggestions???? Much thanks in advance.
Scott
I have replaced the resin, seal kit, disk rotor, switch and motor and am still getting the error. I get the error even if I run the unit in bypass mode. I also get the error even if the switch is disconnected. It always stops when it hits the BW indicator on the cam gear. Also as soon as I plug in the unit it immediately goes into regenerate now mode and I can not get it to not be in that mode.
To me it looks like the only part left that could be bad is the control unit. Any suggestions???? Much thanks in advance.
Scott
Last edited: