(206) 949-5683, Top Rated Plumber, Seattle
Results 1 to 3 of 3

Thread: Which Cutoff Tool Should I Purchase for...

  1. #1
    DIY Junior Member kailor's Avatar
    Join Date
    Dec 2010
    Location
    Huntsville, Alabama
    Posts
    22

    Default Which Cutoff Tool Should I Purchase for...

    ...removing particle board flooring from a mobile home. I'll have to remove this crap from underneath sill plates and am trying to decide on the right tool for the job to cut off nails. Should I get pnuematic, cordless or corded?

  2. #2
    Moderator & Master Plumber hj's Avatar
    Join Date
    Aug 2004
    Location
    Cave Creek, Arizona
    Posts
    25,625

    Default

    Cordless will be the most useful in the long run, after this job is done. The Sears, and other companies', "multitool" may be the one for your purpose or a SawZall with a metal cutting blade.

  3. #3
    DIY Member jetlag's Avatar
    Join Date
    Dec 2009
    Location
    Ga.
    Posts
    84

    Default

    I hope you know what a nightmare that is and also hope it is not a large area you are doing , a battery tool wont run long enough without charge for a job this hard . all you can do is use a sawsall with short wood blade to get close as you can to wall but it is best to just break the particle board so you wont hit plumbing or electric wires . Or you can use a power saw with carbide blade set 3/4 deep . Then you can drill up under plate and use a wood chisel to make a place for the sawsall with a metal blade to get under and cut the nails . there are a lot of electric wires that go up through the plate and they might be hard to see . Also if you take out a very long section you need to put temparary shims so the plate wont drop down .
    Last edited by jetlag; 12-05-2010 at 04:38 PM.

Similar Threads

  1. plumbing hand tool.. for manually striking tool with hammer and driving a cement nai
    By firemanpipes in forum Plumbing Forum, Professional & DIY Advice, Tips & Tricks
    Replies: 17
    Last Post: 07-05-2010, 07:35 PM
  2. City water master cutoff!
    By Porky in forum Plumbing Forum, Professional & DIY Advice, Tips & Tricks
    Replies: 3
    Last Post: 02-23-2009, 08:58 AM
  3. Low Cutoff Pressure Switch?
    By riclun in forum Pumps and Tanks Well Forum & Blog
    Replies: 2
    Last Post: 06-25-2007, 03:04 PM
  4. How to find main cutoff valve
    By daytrade_22209 in forum Plumbing Forum, Professional & DIY Advice, Tips & Tricks
    Replies: 4
    Last Post: 12-23-2005, 11:04 AM
  5. Low pressure cutoff.
    By Jack D Davis in forum Irrigation / Sprinkler Forum
    Replies: 3
    Last Post: 06-30-2005, 06:57 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •