I service a lot of apartments where the panel is in the bathroom behind the door when it is swung open, and also closets as long as there is 3' open space in front of it.
Thanks for all the help everyone!!!!
DO NOT CLIP ANY LEADS!
Pigtail the correct size wire to the current wires.
Do this on both ends to make sure the wires fit the brakers and the receptacles.
Use a double pole 15 amp breaker or use breaker ties.
Yes I am A Pirate-Jimmy Buffett
If its solid wire he would likely have to do that, or it might fit into certain breakers as-is.
Seems like he should have 2 seperate breakers as he is creating 2 seperate 120v circuits.
A shared neutral circuit should have both legs turned off at the same time, thus the double breaker or the ties between them. Then, if either leg has an overload, it shuts both off. Possibly an annoyance. The way around that is a subpanel.
Important note - I'm not a pro
Retired Defense Industry Engineer
I suppose that eliminates any chance of some stray juice in the neutral, but a very small chance it is. Still less annoyance than adding a subpanel. Use the double breaker.
Ballvalve, You should not be giving any information on any electrical install as it is apparent that you have no electrical experience as most everything you have stated is incorrect or just down right dangerous.
OP If that existing cable is a 4 wire you could split it up and install that proper over current protection in the existing panel. No real need to install a new panel anywhere if all you need is 2 circuits.
Sounds like you didnt read the whole thread and other electricians opinions. May as well insult them by name also to be really obtuse.
your last paragraph is what I said. What is "OP"?
Maybe you missed page one.
"OP" usually refers to the "Original Poster" of the thread.
sbrn, still waiting on your apology! Thanks in advance.
Rock pretty much said it all. My only apology will be that I didn't get back to the forum faster and Rock beat me to it.
Ballvalve, I will say it again, by reading your post you have proven to me(and apparently some others) that you are not an electrician. You may be a great plumber(going by your name) but that doesn't make you a good electrician. It's OK, I just don't want you giving advice that has no sound reasoning, code basis or workmanship issues.