Wellmate
New Member
I want to wire a pulsafeeder pump(220v) so it runs when the well pump is charging the pressure tank. Do i wire it to the pressure switch itself....or to the well pump control box. Any ideas. Thanks
Wiring a pulsafeeder chemical solution pump
- Thread starter Wellmate
- Start date
Users who are viewing this thread
In the past I have done it to the pressure switch with a so call pig tail, a short run from the switch with a female and then a male on the pump end so that if needed the pump can be unpluged with out turning off the well pump to undo the wires.
Sponsor
Paid Advertisement
Gary Slusser
That's all folks!
- Messages
- 6,921
- Reaction score
- 22
- Points
- 38
- Location
- Wherever I park the motorhome.
- Website
- www.qualitywaterassociates.com
I always used the switch to a metal receptacle box.
Similar threads
