(206) 949-5683, Top Rated Plumber, Seattle
Results 1 to 7 of 7

Thread: receiver for garage door opener

Threaded View

  1. #1
    DIY Junior Member
    Join Date
    Oct 2010
    Location
    Israel
    Posts
    3

    Default receiver for garage door opener

    I have stanley et380 garage door motor. the receiver stop working. It got supply of 24VAC from the engine box.

    I bought LM138 universal receiver that should work (according to manufacturer) with my motor.

    the receiver has 3 wires. two should connect in parallel with the manual switch and the third should connect to the "COM" terminal (i.e 12 or 24 VDC).

    I did not find any com point in the terminal. How should I connect the receiver ?
    I attached pic of the terminal

    thanks
    Yaron
    Attached Images Attached Images  

Similar Threads

  1. Garage door in RO less than door width?
    By jrfiero in forum Remodel Forum & Blog
    Replies: 2
    Last Post: 06-19-2009, 05:36 PM
  2. Need to Drill Small Hole In Cast Iron Receiver to Install Door
    By engnenk in forum Shower & bathtub Forum & Blog
    Replies: 0
    Last Post: 03-17-2009, 09:26 AM
  3. Garage door opener
    By shluffer in forum Electrical Forum discussion & Blog
    Replies: 8
    Last Post: 01-12-2009, 05:29 PM
  4. framing garage door
    By teamo in forum Remodel Forum & Blog
    Replies: 3
    Last Post: 09-12-2008, 01:52 PM
  5. New Garage Door Installation
    By Mike50 in forum Remodel Forum & Blog
    Replies: 3
    Last Post: 06-14-2008, 01:29 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •