Hi,
I didnt get around to putting in the xfr switch last year, so let’s see if I can get it done.
A couple of quick questions, maybe more later. (I got the pic online and is just for reference.)
My switch will be 30 away and I will be using 4 #10 thhn in sch 40.
1. What height should the power inlet be installed at..?
2 My outside wall between the garage doors looks like the pic. The conduit will come down the wall and I will put some type of pull elbow where it makes the 90 to go through the wall....Can I just go in the back knock-out or do I have to go in the bottom knock out? If the back one, do I just cut a piece of sch 40 to go through the outside wall and put on some type of male fitting with some type of water proof washer?? ..and what would be the proper way to go from the pull elbow to the bottom knockout if that is by code? (I’d rather go in the back, so it won’t be seen (no jokes)).
Thanks in advance,
Homer
I didnt get around to putting in the xfr switch last year, so let’s see if I can get it done.
A couple of quick questions, maybe more later. (I got the pic online and is just for reference.)
My switch will be 30 away and I will be using 4 #10 thhn in sch 40.
1. What height should the power inlet be installed at..?
2 My outside wall between the garage doors looks like the pic. The conduit will come down the wall and I will put some type of pull elbow where it makes the 90 to go through the wall....Can I just go in the back knock-out or do I have to go in the bottom knock out? If the back one, do I just cut a piece of sch 40 to go through the outside wall and put on some type of male fitting with some type of water proof washer?? ..and what would be the proper way to go from the pull elbow to the bottom knockout if that is by code? (I’d rather go in the back, so it won’t be seen (no jokes)).
Thanks in advance,
Homer