Hello Terry and forum members:
I've been enjoying the info in these forums for quite some time, but this is my first post. Using the help found here, I just picked out a new Toto Eco Drake, and installed it last night. I've installed toilets before, but this was my first Toto. My question/issue is this: in tightening down the tank to the three points of contact, I am not quite down rock solid on the front 2 points. It looks like the tank is down, but l can slip a piece of paper in there, and if I pull forward on the tank, I feel a tiny bit of "give." No give pushing back. I hate to tighten the hold-downs any more--I didn't like the noises I was hearing from the tank and there is a lot of pressure on them already. So, do I have a problem that I need to correct, or should I just leave it alone?