I have a dilemma.
In my basement there is a full 1950s rough for a bathroom. It works. Because it was done right.
One day in the future, a long long time away I may fit a finished bathroom there.
The piping is cast iron.
For the toilet I have purchased two flanges in advance:
1) an Oatey twist n set made of cast iron
2) an Oatey cast iron replacement compression type flange BUT only available in PVC or ABS
My dilemma is which to use.
The Twist n Set is made from a superior material but the compression flange is a much better design when it comes to installation and would be much easier to fit in an old 4 inch iron pipe.
Last edited by Ian Gills; 09-22-2010 at 05:25 PM.