Help!! How do I connect the overflow and drain assy to ny new kohler tub?

Users who are viewing this thread

Scott_V

New Member
Messages
20
Reaction score
0
Points
0
Location
California
Once I set the new tub (Kohler Villager) in place I have virtually no access to the overflow and tub drain assy. How do I connect these without cutting a hole in the wet wall and accessing from the adjacent room? I must be missing something obvious?? Or, is this a near impossible task without cutting into the wall to gain access to the plumbing connections?

Thanks
 

Jerome2877

In the Trades
Messages
397
Reaction score
2
Points
18
Location
Vancouver Island , BC
The drain and overflow needs to be put in place before the tub is installed. This can be a little tricky if you havn't done it before. It might take a few times putting the tub in place then pulling it out to get it perfect.
 

Jadnashua

Retired Defense Industry Engineer xxx
Messages
32,771
Reaction score
1,191
Points
113
Location
New England
If you do that, and everything is lined up perfectly, you only get one last chance to glue that last piece in...when you set the tub down.
 
Top
Hey, wait a minute.

This is awkward, but...

It looks like you're using an ad blocker. We get it, but (1) terrylove.com can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.

If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.
I've Disabled AdBlock    No Thanks