maru3445
New Member
Let me preface this with that this is only the 2nd DIY job I have done in regards to plumbing, so I apologize if my terminology is incorrect.
I recently gutted a 1/2 bath on the first floor of my house. I would like to install a pedestal sink but I have ran into a small problem, the waste line from the previous sink goes to the side wall as opposed to the rear wall. The waste line goes straight into a tee joint which in turn is connected to a vertical waste line
What I would like to do is reroute the waste line so that it is contained in the wall but the issue is with the current tee joint/junction that is glued into the vertical waste line. I obviously cannot turn this, so what is the correct way to get a new one installed and facing the direction I need it to face?
Thank you in advance for any help
I recently gutted a 1/2 bath on the first floor of my house. I would like to install a pedestal sink but I have ran into a small problem, the waste line from the previous sink goes to the side wall as opposed to the rear wall. The waste line goes straight into a tee joint which in turn is connected to a vertical waste line
What I would like to do is reroute the waste line so that it is contained in the wall but the issue is with the current tee joint/junction that is glued into the vertical waste line. I obviously cannot turn this, so what is the correct way to get a new one installed and facing the direction I need it to face?
Thank you in advance for any help