Notches and holes in floor joist

Users who are viewing this thread

plaza500

DIY Member
Messages
35
Reaction score
0
Points
0
Location
Canada
Hey there folks

I thought I had a leak in my ceiling, the plaster was cracking a bit, so today I took a knife to it can cut out a section to take a peek.

plaza-02.jpg


Here is what I found - now there is nothing below this, it is my dining room. No support beam whatsoever and the nearest wall is probably 3', 4' and 6' away in either direction.

The beam has three holes drilled in it, and notch cut out of the top.

The beam is almost 6.75" long, and the notch is 2.75" deep.

Do I now have a structural problem and what can be done to correct this?

attached pics

plaza-01.jpg


plaza-03.jpg


Here is where it is
 
Last edited by a moderator:

Jadnashua

Retired Defense Industry Engineer xxx
Messages
32,771
Reaction score
1,191
Points
113
Location
New England
Notches are never good. Holes in the middle, not so bad. A joist gets much of its strength from compressive strength on the top edge, and tensil strength on the bottom edge (sort of like an I-beam or truss that could be mostly hollow in the middle). Cutting it there significantly decreases it's overall strength. Cracks in the plaster show movement.
 

Dlarrivee

New Member
Messages
1,150
Reaction score
0
Points
0
Location
Canada
As far as repairing that notch, I would be tempted to pull the entire ceiling and making sure this isn't a typical practice of whoever may have worked on the home at one time.
 

Ian Gills

Senior Robin Hood Guy
Messages
2,743
Reaction score
3
Points
0
Location
USA
I make a lot of holes in joists because I like to use metallic cable.

I try my best when placing holes.

Plumbers are the worst though when it comes to this.
 
Last edited by a moderator:
Top
Hey, wait a minute.

This is awkward, but...

It looks like you're using an ad blocker. We get it, but (1) terrylove.com can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.

If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.
I've Disabled AdBlock    No Thanks