Benze
New Member
Hi,
I've torn up my basement slab, cut out the segment of my 4" CI pipe with the old BWV and replacing it with a new ABS one. I'm also adding an wye to the drain so I can plumb in my laundry room.
I know that by code you can't use a 90 in the DWV, but can use 2 x 45. I'm running into a situation where I have to run a 45 into a Wye that then turns 45 in the opposite direction. I've managed to slope everything out properly, so it is all roughly a half bubble sloped in the right direction, but don't know if there are too many bends in the line.
I will be adding another 4" BWV about 4' from the Wye (top left corner of the picture), so I figure that I can always use that as a cleanout if really necessary.
This picture is taken from about 5' above the ground.
Thanks,
Eric
I've torn up my basement slab, cut out the segment of my 4" CI pipe with the old BWV and replacing it with a new ABS one. I'm also adding an wye to the drain so I can plumb in my laundry room.
I know that by code you can't use a 90 in the DWV, but can use 2 x 45. I'm running into a situation where I have to run a 45 into a Wye that then turns 45 in the opposite direction. I've managed to slope everything out properly, so it is all roughly a half bubble sloped in the right direction, but don't know if there are too many bends in the line.
I will be adding another 4" BWV about 4' from the Wye (top left corner of the picture), so I figure that I can always use that as a cleanout if really necessary.
This picture is taken from about 5' above the ground.
Thanks,
Eric
Attachments
Last edited: