Coopns
Member
I have a quarter turn angle valve 1/2 sweat. I am going to sweat it on the the 1/2 copper to connect the toilet.
Can someone confirm the steps:
1. Cut off exsiting rusted valve off 1/2 copper
2. Sand copper nub coming off wall
3. Attach vlalve on copper with flux
4. Heat both up and apply solder.
Heating the valve, with that screw it up at all? Just kind of stay away from the handle?
Let me know if I am missing anything. Obviously a rookie.
Can someone confirm the steps:
1. Cut off exsiting rusted valve off 1/2 copper
2. Sand copper nub coming off wall
3. Attach vlalve on copper with flux
4. Heat both up and apply solder.
Heating the valve, with that screw it up at all? Just kind of stay away from the handle?
Let me know if I am missing anything. Obviously a rookie.