Seattle38
New Member
I'm in a bit of a bind. I've been in the process of installing a new copper water main (one inch type L soft) from the meter to the house. the line is laid, but the copper tubing at the meter end is slightly oblong, not round. After screwing around with it and attempting to sweat it four times (still leaking), I'm at a loss at this point. I sweated the other end in the house, not problem, this end was round.
I either need a good plumber who can get the tubing hooked up for me at the meter, or perhaps a different type of connection;
do one inch brass compression fittings exist??? Where can I get one if they do?
Thanks!
I either need a good plumber who can get the tubing hooked up for me at the meter, or perhaps a different type of connection;
do one inch brass compression fittings exist??? Where can I get one if they do?
Thanks!