chargedmr2
New Member
I've just finished installing my 2510SXT and need to get the programming set up for efficient potassium chloride use.
Total Hardness = 11
No Iron (city water)
Two adults
1.5 cu ft system
BLFC = .5gpm
What should I set the following parameters to?
Unit Capacity
Safety Factor
Day Override
Backwash
Brine Draw
Rapid Rinse
Brine Fill
Also, does anyone know what setting I should use for valve type? The default setting is Df1b, but the manual makes no mention of this specific selection. The closest setting in the manual seems to be St1b (Standard downflow/uplow, single backwash), but again, the default setting (df1b) is not described or mentioned anywhere.
Thanks for your help!
Total Hardness = 11
No Iron (city water)
Two adults
1.5 cu ft system
BLFC = .5gpm
What should I set the following parameters to?
Unit Capacity
Safety Factor
Day Override
Backwash
Brine Draw
Rapid Rinse
Brine Fill
Also, does anyone know what setting I should use for valve type? The default setting is Df1b, but the manual makes no mention of this specific selection. The closest setting in the manual seems to be St1b (Standard downflow/uplow, single backwash), but again, the default setting (df1b) is not described or mentioned anywhere.
Thanks for your help!