Bassman
DIY Member
I'm looking at the CA Plumbing code and it says:
706.1
"Changes in direction of drainage piping shall be made by appropriate use of approved fittings and shall be of the angles presented by a one-sixteenth (1/16) bend, one-eighth (1/8) bend, or one-sixth (1/6) bend, or other approved fittings of equivalent sweep."
I can't figure out why a right angle is not included in this list. Are there no 90 degree bends in drain pipes? Thanks for any help.
Neil
706.1
"Changes in direction of drainage piping shall be made by appropriate use of approved fittings and shall be of the angles presented by a one-sixteenth (1/16) bend, one-eighth (1/8) bend, or one-sixth (1/6) bend, or other approved fittings of equivalent sweep."
I can't figure out why a right angle is not included in this list. Are there no 90 degree bends in drain pipes? Thanks for any help.
Neil