ericbar
New Member
- Messages
- 14
- Reaction score
- 0
- Points
- 0
I ran my well dry two weeks ago by overusing my pressure washer over the course of two days. I shut off my pump immediatedly to be sure I didn't burn up the submersible pump and was out of town for two weeks. Upon returning two weeks later the well water level was back to normal. The problem is that now I can't get the water tank pressure to build up properly when the pump is on. I have a 40 60 switch but it has clicked on and off at much lower and higher psi. I have tried adjusting the cut on and cut off but it hasn't worked. It would cut on at 44 psi and cut off at 46 psi before I began adjusting. I was able to get it to cut on at 40 psi and cut off at 53 psi, but now it is all over the place as I try adjusting it. it will dip down as low as 30 psi as I adjust. I am wondering what this could be. FYI, I checked the nozzle on top with a tire guage and it was 40 psi. Any guidance would be much appreciated.