Hello,
Hoping somebody can guide me.
I've got a Hunter Pro-C control that runs though a pump relay switch turns the well pump on for each zone. Problem is that the system works fine on station one, but when I try to run stations two or three, the controller indications everything is working fine, but doesn't want to trigger the switch to turn the pump on.
Any ideas? Thanks,
Hoping somebody can guide me.
I've got a Hunter Pro-C control that runs though a pump relay switch turns the well pump on for each zone. Problem is that the system works fine on station one, but when I try to run stations two or three, the controller indications everything is working fine, but doesn't want to trigger the switch to turn the pump on.
Any ideas? Thanks,