Regis Tration
New Member
I have a well in a very remote location close to the ocean, where it is exposed to salt air. The portion of the well casing that is above the soil is severely corroded.
I would like to replace the corroded casing.
I had in mind to dig out the soil surrounding the casing a few inches deep, cut away or break away the portion of the casing that is corroded, push a sleeve down over the part that is not corroded, and then insert a new piece of casing into the other end of the sleeve.
It is very unlikely that I could get a welder to come to the well, so I am looking for a solution that does not involve welding.
Can anyone recommend a good method and products please?
I would like to replace the corroded casing.
I had in mind to dig out the soil surrounding the casing a few inches deep, cut away or break away the portion of the casing that is corroded, push a sleeve down over the part that is not corroded, and then insert a new piece of casing into the other end of the sleeve.
It is very unlikely that I could get a welder to come to the well, so I am looking for a solution that does not involve welding.
Can anyone recommend a good method and products please?