DIYERFROMVA
New Member
Just about to replace a Moen 1225 brass cartridge with a plastic one. From what I gather, they can be tough to remove without the removal tool.
Questions for the pros out there.
Should I buy the tool before attempting to remove the old one?
Is the tool made by Danco sufficient, or should I spring for the one made by Moen?
Any othe general tips you can share would be appreciated.
Thanks a bunch!
Questions for the pros out there.
Should I buy the tool before attempting to remove the old one?
Is the tool made by Danco sufficient, or should I spring for the one made by Moen?
Any othe general tips you can share would be appreciated.
Thanks a bunch!