I ALWAYS USED ONE OF THESE ! !
INTERNAL PIPE CUTTER
Just wondering what all you guys are using for internal pipe cutters? ie cutting the toilet pipe below floor level to install a flange. Usually find this situation when finishing a basement that was roughed-in during the building stage.
I slide the flange over the pipe, and then saw it off flush with the top of the flange. But then, I always use a 4" riser pipe. When it is a 3" riser that someone else installed, then I use the Ridgid #109 internal cutter.
Last edited by hj; 06-09-2010 at 07:26 AM.
I use a Reed internal pipe cutter. I also carry both the carbon cut off disk and the steel saw blade to go with it.