(206) 949-5683, Top Rated Plumber, Seattle
Results 1 to 2 of 2

Thread: Water Mate WM-6 question.

  1. #1
    DIY Junior Member Ryan Seamone's Avatar
    Join Date
    Jun 2010

    Default Water Mate WM-6 question.

    Well I am still trying to figure out whats going on with my pump and stuff ( have an earlier post ). The pump is still running all the time.
    Anyways , my tank is a WaterMate WM-6 captive air tank. I wasns sure about the opperating pressure and the tank itself said 125psi ( which i thot was high ) so I googled it and found that they are set at 40 and adjusted to meet specific needs when they are installed. I grabbed a mirror and say mine was at 20. So i upped the pressure to 40. Still no difference. I can hear water sloshing a few inches from the top when I move the tank, but I dont get any water out of the shraeder valve.
    And now the air pressure is back bown to 20psi, any suggestions ?

  2. #2
    General Engineering Contractor ballvalve's Avatar
    Join Date
    Dec 2009
    northfork, california


    start with a new tank.

Similar Threads

  1. 2nd Gerber Viper with problems? Tank to bowl wont mate level......
    By Dr_Jim in forum Toilet Forum discussions
    Replies: 0
    Last Post: 01-18-2010, 03:39 PM
  2. Water heater question - cold water, water leaking thru overflow pipe
    By jonyi in forum Plumbing Forum, Professional & DIY Advice, Tips & Tricks
    Replies: 6
    Last Post: 09-26-2009, 01:26 PM
  3. Flush-Mate toilet at new Motel 6
    By mjnelson99 in forum Toilet Forum discussions
    Replies: 2
    Last Post: 06-25-2007, 05:55 AM
  4. Flush Mate
    By jleeo in forum Toilet Forum discussions
    Replies: 1
    Last Post: 04-26-2005, 12:52 PM
  5. Question about flush-mate
    By zorro55555 in forum Toilet Forum discussions
    Replies: 4
    Last Post: 04-20-2005, 04:36 PM


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts