NovicePiper
Not a Master Plumber
Final Layout V1
Hi Terry - Thanks for getting back to me
So I changed the venting for the sink so it's more direct - more pipe but but I'm not concerned with that - I just want it to look good and pass inspection - hopefully I can get this done over next few days/end of week and post back pics so I can schedule an inspection etc.
The Horizontal vents will have a 1/4 p ft rise away from the drain so any water drains from the main vertical vent to the main sewer line - I think thats right based on what ive read on hear..
Just a couple of questions before I go buy the stuff:
Q1 - Do I need a cleanout for the sink line?
Q2 - Does the cleanout for the washing machine have to stick out of the wall like the pic or can it turn 90 degress to the left and be flat into the wall cavity?
Q3 - The washing machine 2" P-Trap, should this be sealed or have a small plug in the bottom like the sink P-Trap?
Q4 - Any advice regarding the correct procedure for joining in the 2" to the clay 4" - I was thinking about using a Fernco Band and then reducing using ABS and Bush etc...or if they have a straight forward 4" to 2" do it that way?
ALSO - Is Canada NPC - am I still ok to run the ' below grade stuff in 2" '
Thanks and I really appreciate this super forum - it's the shizzle!
Regards
NP
Hi Terry - Thanks for getting back to me
So I changed the venting for the sink so it's more direct - more pipe but but I'm not concerned with that - I just want it to look good and pass inspection - hopefully I can get this done over next few days/end of week and post back pics so I can schedule an inspection etc.
The Horizontal vents will have a 1/4 p ft rise away from the drain so any water drains from the main vertical vent to the main sewer line - I think thats right based on what ive read on hear..
Just a couple of questions before I go buy the stuff:
Q1 - Do I need a cleanout for the sink line?
Q2 - Does the cleanout for the washing machine have to stick out of the wall like the pic or can it turn 90 degress to the left and be flat into the wall cavity?
Q3 - The washing machine 2" P-Trap, should this be sealed or have a small plug in the bottom like the sink P-Trap?
Q4 - Any advice regarding the correct procedure for joining in the 2" to the clay 4" - I was thinking about using a Fernco Band and then reducing using ABS and Bush etc...or if they have a straight forward 4" to 2" do it that way?
ALSO - Is Canada NPC - am I still ok to run the ' below grade stuff in 2" '
Thanks and I really appreciate this super forum - it's the shizzle!
Regards
NP
Attachments
Last edited: