(206) 949-5683, Top Rated Plumber, Seattle
Results 1 to 7 of 7

Thread: Double check my plan

Hybrid View

  1. #1

    Default Double check my plan

    I have 3 questions.

    First, do i just use a regular 1.5" elbow in the upper right?
    Second, do i just use a regular 2" elbow in the lower left?
    Third, can i use a 2" santee in the bottom right instead of a 2" wye + 45 (store don't got no combos)?

    Oh - and any other problems you see?

    - I just realized, you may want to know, this is for a double bowl kitchen sink.

    Thank you in advance.

    Last edited by pghsebring; 03-30-2010 at 10:13 AM.

  2. #2
    Forum Admin, Expert Plumber Terry's Avatar
    Join Date
    Aug 2004
    Location
    Bothell, Washington
    Posts
    14,191
    Blog Entries
    1

    Default

    The 2" 90 El below the tee on the left would be a long sweep.

    The 1.5" 90 el on the vent, can be a vent 90 or a med 90
    I normally carry med 90 and long turns, no vent 90'sin the truck.
    They are a fitting that is rarely used.

    Inspectors like to see a 2" cleanout.

    Last edited by Terry; 06-02-2010 at 04:33 PM.

  3. #3
    Master Plumber-Gas Fitter shacko's Avatar
    Join Date
    Jan 2006
    Location
    Rosedale, Md
    Posts
    561

    Default

    Agree with Terry about the ell and a c.o. If your sink bowls are two different depths make sure you put your rough-in low enough for the lowest bowl.

  4. #4

    Default

    Thanks guys, now i just need my third question answered -

    Can i use a 2" santee in the bottom right instead of a 2" wye + 45 (store don't got no combos)?

    All of this is sitting in one stud bay BTW - less than 16" wide.

    Thanks again.

  5. #5
    One who lurks Basement_Lurker's Avatar
    Join Date
    Jun 2007
    Location
    Victoria, BC
    Posts
    668

    Default

    Yes you could use a santee to make the transition instead of a wye.

    I am curious as to why you are trapping each sink, are you just doing it out of preference or is it code where you are?
    Broken promises don't upset me. I just think, why did they believe me? -Jack Handy


    www.blackbirdkitchenandbath.com

  6. #6

    Default

    Preference while i have the wall open. I figure it can't hurt. I'm gonna have two sinks, dishwasher and garbage disposal, this makes it easier later i do believe. One sink into wall, disposal into wall, nice and clean.

    Thanks for the help.

  7. #7
    Moderator & Master Plumber hj's Avatar
    Join Date
    Aug 2004
    Location
    Cave Creek, Arizona
    Posts
    25,602

    Default

    Lont turn elbow on the left, sanitary tee on the right, and a tapped c.o. tee in place of the vent tee. 1 1/2" tapped tee meets the requirement for a full size opening, vent tee does not. Why go to all that trouble? There are easier ways to do it, and I only make multiple inlets when it will be a triple sink.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •