As I posted before, I'm working on adding a shower to an existing half bath. I'm getting ready to start the rough plumbing and normally for something like this I would install shut off valves on the hot and cold water supply going to the shower... but there really isn't any place to put them that wouldn't get sealed into the wall. It's going on the first floor of a house on a slab, so I can't put them in the basement or anything. The other showers in the house either don't have shut off valves or they're inside the wall and inaccessible as well.
Do I just not install valves for this shower or do I install them and then seal them into the wall?
Thanks,
Brett
Do I just not install valves for this shower or do I install them and then seal them into the wall?
Thanks,
Brett